Is it necessary to completely submerge the filter in water?
Internal filters must be completely submerged in water to work properly. …Then it disperses on the surface of the water. The air bubbles create much-needed movement in the water, allowing you to filter liquid throughout the aquarium.
Does my filter need to be underwater?
Water is taken from the aquarium and pumped through the filter box, then by gravity through the insert cartridge it enters the aquarium. If you have a basket filter, the outlet should be 1.5 to 2 inches below the surface of the water (fully submerged) and facing the surface for optimal movement.
How tall should an aquarium filter be?
Keep an eye on the amount of water in your tank – most filters require the water level to be about 1 inch from the edge of the filter. Make sure bladder walls and/or air stones are not directly under the inlet tube. If bubbles return from the main tube, they will click and may cause the filter to rupture.
How to put a filter in an aquarium?
Aquarium immersion heaters can be completely submerged in aquarium water. …If your immersion heater has an internal thermostat, it will generally be more efficient if you place it horizontally in the tank and low enough in the water column.
Do I have to completely submerge the aquarium heater?
Aquarium immersion heaters can be completely submerged in aquarium water. …If your immersion heater has an internal thermostat, it will generally be more efficient if you place it horizontally in the tank and low enough in the water column.
Why is my filter not producing bubbles?
If there are no bubbles, the filter may not be working. Therefore, repair or replace the filter. The most likely cause is disconnected or clogged filter air hoses or a faulty air pump (see Q1). … If the filter and pump work and the tank is still cloudy, the water is contaminated.
Does the filter supply oxygen to the water?
Filters are of great importance in increasing the oxygen level in the water, forcing the water to move to the surface where oxygen exchange takes place. … Anything that lifts water to the surface or sprays it into the air also increases oxygenation.
Can too strong a filter kill fish?
Putting these latter species in a strong current can stress them out and weaken their immune systems. But if you mean “strong filter” as a filter system that can filter a much larger aquarium system than the one it is attached to. Therefore, the answer is no. It is not possible to over-filter an aquarium system.
Can the filter be too strong for the fish?
The answer to filters that are too strong is yes. The flow of water created causes more problems than the increased seepage. There are fish that do not like strong water currents and if they are too small they can be sucked into the basin.
Should an aquarium filter bubble?
It is normal for aquarium filters to form bubbles. However, if the filter produces more bubbles than normal, this is cause for concern.
Should there be a cartridge filter under the tank?
cichlid Absolutely not to overdo it, as the tubes are not made to bend. The inlets and outlets of most cartridges are face up. So under and near the tank on the ground is fine because the hoses are quite long as well.
Can aquarium heaters be turned on and off?
An aquarium heater converts electricity into heat. …All aquarium heaters turn off when the set temperature is reached. You don’t have to worry about the water overheating. When the water is colder than the set temperature, the heater turns on automatically.
Where to place the heater in the aquarium?
Think about the right place for the heater in the aquarium. Locate the heater close to the inlet/outlet of the filter or circulation pump to ensure even heat distribution. Aquarium immersion heaters can be installed horizontally at the bottom of the aquarium for best results.