1/4 to 3/8 inch Most shingle manufacturers recommend an overhang of 1/4 to 3/8 inch above your eaves where your roof ends in your gutter. In many cases, and particularly as the house ages and settles, the roof edge to the eaves edge can buckle more than this amount.
How far should the shingles protrude beyond the drip edge?
Asphalt shingles should extend beyond the outside edge of the drip edge by ¼ to ¾ inch. Check local building codes for drip edge requirements before beginning your roofing project.
How far should the shingles protrude over the eaves?
The edge of the shingles should hang between an inch and an inch and a half above a roof — or between a half and three-quarters of an inch if a drip edge flashing is installed. Too much overhang and the shingles could fly away in high winds, too little can cause water to get into the rake or fascia boards.
Should there be space between the roof and the gutter?
The gap is not necessary. Remove the wood blocks and install a 4″ gutter of the same size as the gap is too small to tell the difference. Do not remove the blocks and install the same size gutter without modifications.
How do you extend a shingle roof over a gutter?
Position the flashing under the row of shingles closest to your gutter. Slide a full length of sheet metal under multiple shingles at a time. For example, if your flashing is 8 feet, slide it under 8 feet of shingles. Adjust the edging so that it extends beyond the gutter.
How far should the shingles protrude from the drip edge?
Shingles should be installed at least 3/8 inch (9mm) above the drip edge on both the eaves edge and the rake edge. When the drip edge extends out of slopes and eaves (commonly referred to as DL style or D type), shingles can be installed flush with the drip edge.
How far should the drip edge reach?
The drip edge must protrude at least 6.4 mm (1/4 inch) below the roof skin and at least 51 mm (2 inches) onto the roof surface.
How far do the eaves stick out?
Overhangs can vary from a few inches to a few feet depending on preference, but the recommended width of an overhang is between 12″ and 18″ for eaves and no more than 8″ for rakes. Overhangs can be up to 2 without the need for external supports.
How are the shingles laid on the drip edge?
How should the shingles be installed over the drip edge? Shingles should be installed at least 3/8 inch (9mm) above the drip edge on both the eaves edge and the rake edge. When the drip edge extends out of slopes and eaves (commonly referred to as DL style or D type), shingles can be installed flush with the drip edge.
How do I extend my roof overhang?
Begin by installing a new metal drip edge along the edge of the new overhang. You can then lay a row of new shingles along the bottom edge. Work your way up the remaining rows until you reach the existing clapboards. At this point, slide the last row of new shingles under the old shingle tongue
Can a roof be replaced without removing the gutters?
It is possible to leave the gutters in place during a roof renewal. … If your gutters are installed this way, a new roof installation will not affect the gutters and therefore the roofer will not have to remove the gutters. In other cases, installing a new roof can damage the gutters.