How to avoid the accumulation of thread?
Hold the thread with both hands while pulling lightly. The cable is located on the belt tensioner. Also check that the thread is positioned correctly between the tension discs at the top of the machine: if it is not positioned correctly, it will not have tension and will pull from the first stitch.
Why is my thread stuck at the bottom?
A: A loop at the bottom or wrong side of the fabric means that the upper thread tension is too loose relative to the bobbin thread tension, causing the bobbin thread to pull too hard on the upper thread. under. Increasing the top tension will stop the curls, but too much tension can cause breakage, especially when working with fine strands.
What are the causes of wrinkles when sewing?
Tension wrinkles occur when you sew with too much tension, causing the thread to stretch. After sewing, the thread loosens. In an effort to regain its original length, it grabs at the seam and causes wrinkles that are not immediately noticeable and may be noticeable later.
Why did my thread get stuck under the Singer sewing machine?
Loops on the wrong side of the fabric always indicate that the upper thread is not threaded correctly. This occurs when the upper thread is not placed correctly in the tension mechanism and does not pass through the thread tension table.
How to stop thread merging?
A good cleaning can fix problems with your kit (refer to the cleaning and maintenance instructions for your machine, which may also require lubrication). To avoid sewing problems, regularly remove dust under the needle plate and along the thread path, and clean and oil the machine regularly.
Why does my sewing machine keep making knots at the bottom?
Improper Threading
If the sewing machine is not threaded correctly, the bobbin thread will not pass through the fabric correctly. Sometimes the upper thread can become tangled or tangled in the moving part, preventing the thread from passing easily through the needle and causing tangles.
Why does the sewing machine thread bend?
The ends of the thread are too short.
If the ends of the thread coming off the spool are shorter than 5 cm, they may enter the sewing machine when you start sewing. This could cause the thread to pucker under the fabric.
How to repair bobbin thread collection?
How to Solve Bobbin Thread Jam and Other Threading Problems
- Refuel the car correctly. Thread the top of the sewing machine again, making sure the thread passes through each thread guide on its way to the needle. …
- Change needle. …
- Check the coil. …
- Clean your device.