To reset an airbag light
- Insert the key in the ignition and turn the switch to the on position.
- Wait until the airbag light comes on. It stays on for seven seconds and then turns off. Once it turns off, turn off the switch immediately and wait three seconds.
- Repeat steps 1 and 2 two more times.
Can you reset the airbag light without tools?
It is impossible to reset the airbag light without a scanner on most car models. These are safety precautions as you should always troubleshoot after the airbag warning light comes on. Fortunately, the airbag light will also turn itself off on many car models once you have fixed the problem.
What resistance do I need to bypass the airbag?
#2: To bypass the driver’s airbag you will need a 3.9 ohm, 5 watt resistor.
Is it safe to drive with the airbag light on?
It is unsafe to drive with the airbag light on. If the light is on, it means there is a problem with the airbag system. If there is a problem with the system, it will not deploy the airbags at all in a crash. …If your airbags fail to operate in a crash, it could result in death or serious injury.
What does it mean if the airbag light stays on?
The airbag warning light should only remain on if there is a problem with the vehicle’s airbag system. … The light comes on for a few seconds and then goes off to indicate that it’s working. If it stays on, there is a problem with the system and the airbag may not deploy in a crash.
Does disconnecting the battery reset the airbag light?
To get rid of this annoying light, it is often sufficient to reset the airbag sensor. …Remove the connector and leave it disconnected for 510 seconds to allow the airbag sensor to reset. Then reconnect the battery clamp and turn on the vehicle. I hope the light stays off.
How do I check the resistance of the airbags?
If your van only has a driver’s airbag, look under the seat and you will see 2 small wires connected to a bright orange connector. With the ignition key in your pocket and not in the ignition switch, unplug this connector. Spray connector tabs and reassemble. The light will probably go out. 3
Can I disconnect my airbag?
However, the passenger airbag can be deactivated if the vehicle is equipped with a passenger airbag disable switch (PACOS). In most cases, to deactivate the airbag, the ignition must be switched off to avoid possible malfunctions. The PACOS is usually located on the passenger side of the dashboard.
Will clearing the fuse disable the airbag?
Every vehicle I’ve worked on had an airbag fuse that you can remove from the fuse box to completely disable the airbag. Repair manuals recommend pulling this fuse when doing any work in the dashboard area, as there is a risk of the airbags deploying while you are doing so. Work that can lead to serious injuries…