Is it possible to just screw the concrete plate?
screws and gaskets
Do not use drywall screws as they are not recommended for attaching the baseboard. All parts of the back panel must be cut before laying on the floor. … It is important to note that the screws must not be attached to the floor joist.
How to screw a concrete board?
Set the HardieBacker concrete pad firmly and evenly into the wet mortar. … Using the specified nails or screws (listed in the Materials Needed section), secure the HardieBacker concrete pad every 8 inches across the entire surface. Hold fasteners 3/8″ to 3/4″ from the edges of the cards and 2″ from the corners of the cards.
Can you screw a sturdy board?
Set the HardieBacker concrete pad firmly and evenly into the wet mortar. … Using the specified nails or screws (listed in the Materials Needed section), secure the HardieBacker concrete pad every 8 inches across the entire surface. Hold fasteners 3/8″ to 3/4″ from the edges of the cards and 2″ from the corners of the cards.
Is it possible to just screw the concrete plate?
screws and gaskets
Do not use drywall screws as they are not recommended for attaching the baseboard. All parts of the back panel must be cut before laying on the floor. … It is important to note that the screws must not be attached to the floor joist.
How to lay a concrete board?
Concrete planks attached to plywood or similar support are held in place with 1 1/4″ wood screws only. Use 1 5/8″ screws for thick or heavy metal fasteners. Typically, 1 1/2-inch galvanized nails hold the board securely in place.
What kind of screws do you use to fix the concrete slab?
screws and gaskets
Do not use drywall screws as they are not recommended for attaching the baseboard. All parts of the back panel must be cut before laying on the floor. … It is important to note that the screws must not be attached to the floor joist.
Is it possible to just screw the concrete plate?
screws and gaskets
Do not use drywall screws as they are not recommended for attaching the baseboard. All parts of the back panel must be cut before laying on the floor. … It is important to note that the screws must not be attached to the floor joist.
Can screws be used in a Hardie plate?
HardiePlank® sheathing panels can be used with ICCES approved ESR2290 fasteners placed in accordance with wind load tables. Fasteners must be stainless steel, galvanized, or corrosion resistant.
Are there special screws for rigid boards?
What type of fasteners do you recommend for installing HardieBacker® concrete slabs on floors and walls? Depending on the shingle industry, James Hardy recommends 11/4 galvanized roofing nails or stainless steel roofing nails (HD 0.121 x 3/8 shank) or 11/4 long rib corrosion resistant screws (#.